Anthropic reported on November 9, 2026, that Claude Fable 5.2 helped design three electronics prototypes with Diode Computers: a USB-C speakerphone, a home voice-assistant hub and a handheld virtual pet. Diode engineers assembled the boards and ran the firmware. Anthropic said the prototypes operated without circuitry fixes but had not undergone formal electrical validation, antenna tuning, thermal testing or certification. Anthropic’s account also disclosed a commercial relationship with Diode.
Design files and a working prototype are useful milestones; they are not the same as a product that has completed validation.
Claude handled design files; Diode handled the physical build
Anthropic says Claude produced specifications, schematics, PCB layouts, enclosure designs, firmware and parts lists, and directed parts of the design process. Diode’s engineers built the boards and ran the firmware. Claude was not connected to test equipment or the manufacturing and assembly machines.
The speakerphone illustrates how specific the design work became. Its requested functions included USB-C, microphones, a speaker, Bluetooth and a PCB antenna. Anthropic says its board had four copper layers; Claude changed signal assignments on two chips to route tracks beneath the touch-sensitive controls on one layer. During enclosure installation, the board needed to be tilted about 25 degrees to clear the mute-switch knob.
For the voice-assistant hub, Claude used a KiCad routing workflow supplied by Diode for USB and Ethernet pairs, then wrote a grid-search router for longer tracks from a 100-pin connector. Anthropic says the custom router took about 30 minutes to write and routed each long track in roughly a second. Claude also adjusted clearance around sensitive audio-clock tracks.
The hub’s microphone ports prompted another design calculation. Anthropic says Claude estimated that a 25 mm port would resonate near 3.4 kHz, while shortening it to about 10 mm would raise the calculated resonance to about 8.9 kHz. These figures describe the design calculations Anthropic reported.
The two benchmarks measure different tasks
Anthropic reported results for two benchmarks, each focused on a different kind of engineering task:
| Benchmark | Task | Reported result |
| PCB Gym | Place components and reroute connections on boards with their original layouts removed | Claude Fable 5.2: 69%; Claude Fable 5: 25% |
| BenchCAD 2.1 | Reconstruct 3D parts, assemblies and circuit boards from engineering drawings and rendered images | Claude Fable 5.2: 83.5% |
The PCB Gym figures compare two models on the same benchmark. The BenchCAD score describes a separate reconstruction task, so its percentage is not directly comparable with PCB Gym’s. Neither benchmark score substitutes for electrical, antenna or thermal validation of a physical device.
Prototype operation is not product validation
Anthropic said the three prototypes worked and their circuitry needed no manufacturing fixes. The company also said they had not undergone electrical validation, antenna tuning, thermal testing or certification, and were not designed for mass production. Those are distinct stages: operating a prototype does not by itself establish that its design is ready for a certified, manufacturable product.
A separate Claude-to-EDA project offers a practical example of human review in the workflow. Developer Salitronic described an experimental Claude Code integration with Altium Designer for a 54 mm round board with 61 LEDs and a 90-ohm USB pair. Salitronic said Claude generated manufacturing files and revised the design after receiving a review list, while recommending a manual pass before prototyping, backups and checks for partial changes if a tool operation failed. Salitronic’s account concerns a separate project from the Diode collaboration.