JEDEC announced a preview of its DDR6 DRAM standard on November 18, 2026. The standard remains in development, and its target of more than 50% higher bandwidth at introduction concerns memory bandwidth—not an equivalent increase in application speed. JEDEC says the proposed features may change during development and approval, and the JEDEC Board may disapprove the standard. JEDEC’s announcement sets out the current proposal.

Treat the 50% figure as a memory-bandwidth target, not a forecast for how much faster software will run.

What the bandwidth target means for applications

Silicon Steak’s video offers a technical commentary on JEDEC’s DDR6 preview.

For DDR6 RDIMMs, JEDEC proposes a starting data rate of 12.8 GT/s, with a roadmap to 14.4 GT/s and beyond. Its DDR5 comparison reference is 9.2 GT/s. The proposed data bus grows from 64 to 96 DQ, which JEDEC describes as a 50% increase in bus width.

MeasureDDR5 reference in JEDEC’s releaseDDR6 proposal
RDIMM data rate9.2 GT/s12.8 GT/s at the proposed starting point; roadmap to 14.4 GT/s and beyond
Data bus64 DQ96 DQ
Module length133 mm74 mm

The more-than-50% target is about bandwidth; JEDEC does not present it as an equivalent performance gain for applications. The proposed 74 mm module length is a separate design figure: JEDEC also lists RDIMM, UDIMM and CAMM as possible formats still being defined.

Other changes in JEDEC’s DDR6 proposal

JEDEC proposes pseudo-channel access, twice the bank count and improved refresh to support bus efficiency at higher speed grades and capacities. The plan also targets DRAM die densities of up to 128 Gb and includes die-stacking optimizations intended to increase density per package footprint.

For power efficiency, JEDEC proposes VSS-terminated I/O and low-power modes aimed at data centers, with the goal of improving performance per watt. The proposal also includes multiple system-level error-correcting code (ECC) implementations, which would let system designers balance cost, power and reliability.